Filter
Top Products
2
Section 1 - General Information
Congratulations on purchasing a MaxTech 15-inch Color Monitor. The
monitor has one of the finest CRTs available in the industry, providing a
full range of video display resolutions and complies with the MPR-I
standard to reduce electromagnetic emissions.
The monitor has a 0.28 mm dot pitch display with a 75 MHz video
bandwidth. It supports video resolutions ranging from 640 x 350 to 1280
x 1024 (non-interlaced).
The monitor can be used with video cards supporting VGA, SVGA, IBM
8514/A or XGA modes and provides an unlimited palette of colors.
1.1 Precautions When Using the Monitor
When setting up and using your monitor, pay special attention to the
following:
• To eliminate eye fatigue, do not use your monitor against a bright
background or where sunlight or other light sources will shine directly
on the monitor.
• Your monitor should be placed just below eye level for optimum
viewing.
• Allow adequate ventilation around the monitor so that heat from the
monitor can properly dissipate.
• Neither the monitor itself nor any other heavy object should rest on the
power cord. Damage to a power cord can cause fire or electrical
shock.
• Keep the monitor away from high capacity transformers, electric
motors and other strong magnetic fields.
• Do not use your monitor in a damp, dusty or dirty area.
• Handle the monitor with care when transporting.
• Unplug the monitor during electrical storms.
1.2 Power Saving Modes
The MaxTech monitor supports VESA Display Power Management Sig-
naling (DPMS) SUSPEND and OFF modes. DPMS defines a method for
a computer to signal the monitor to reduce its power consumption when
idle. DPMS features must be supported by both the computer and the
monitor for them to be available. Computer support of DPMS requires the
use of a DPMS compliant video card.
The monitor enters DPMS SUSPEND mode when the computer turns off
the Vertical Synchronization signal. This power-saving mode reduces the
monitor’s power consumption to 25W. While in this mode the first LED in
the Power Indicator (LED A in Figure 3-1) is off. When the synchronization
signal is re-enabled the monitor returns to normal operation.
The monitor enters DPMS OFF mode when the computer turns off both the