Filter
Top Products
6
4. When the reboot is done, you will be asked to enter your password. Enter it,
then press the Enter key or click OK. Your unit in now ready for use. To register
your unit, continue to Section 5.
4.4 Assigning an IP Address
1. Not every unit will show a panel for assigning an IP address. If your unit
shows this panel, then your workstation is on a different subnet than your
MaxAttach unit. This means that your unit is acting as a DHCP server. Consult
your network administrator and assign a new IP address and subnet mask. If
you connect to the Internet using an ISDN line, consult your internet service
provider for an available IP address.
2. After you have assigned an IP address, click Next. Then click Reboot. When
done, you will be asked to enter your password. Enter it, then press the Enter
key or click OK.
3. You now need to change the range of IP addresses that your MaxAttach unit
can assign. To do this, click on Manage Networks, and then click on the DHCP
server tab. Modify the range according to your new address. Click Apply.