Filter
Top Products
Lancast 8-Port CenturySwitch 9
Apply Power
The CenturySwitch is equipped with an internal 100-240V, 50-60Hz,
25W power supply. When making power connections, connect the power
cord to the input jack located on the back of the switch before making the
AC connection to the outlet.
5
IMPORTANT: If the CenturySwitch loses power, wait at least 10
seconds before applying power again.
The CenturySwitch is shipped with a standard North American 3-pin
power cord which is UL (USA), CSA or CUL (Canada) listed or ap-
proved. For installation in regions outside of North America, replace the
power cord with a cord approved by the appropriate safety agencies. Any
cord used must have a CEE-22 standard V female connector on one end
and meet IEC 320-030 specifications. European power cords must be
harmonized and designated with a HAR marking on the cord jacket to
comply with the CENELEC Harmonized Document HD-21.
The CenturySwitch does not have a power switch. After connecting the
unit to the AC receptacle, check that the PWR (power) LED is illumi-
nated. A steady green light indicates the unit is receiving power.
Once power is applied to the unit, use the individual Link/Act LEDs on
the front panel to verify correct segment connectivity.
AC Line: 100-240V 50-60Hz
AC Power Socket
MADE IN TAIWAN