Filter
Top Products
Base of Stand
4
Figure 1
Figure 2
Figure 3
Stand Installation
With the Metrologic stand (Part
#45475), the scanner can be
positioned in one of two directions.
The two orientation choices are
vertical or horizontal. (Refer to
Figure 1)
To install this stand, use the four 6-
32 x ½ inch machine screws and two
#10 panhead wood screws.
1. Drill two holes into the work
surface that are the same size
and distance as the holes on
the stand base. (Refer to Figure
2)
2. Use the two #10 panhead
wood screws to attach the
stand to the work surface.
3. To fasten the scanner:
! For a horizontal mount,
align the four holes on the
back of the scanner with
the four clearance holes
located on the stand
marked with an X in
Figure 3.
! For a vertical mount, align
the four holes on the back
of the scanner with the
four clearance holes
located on the stand
marked with a Y in Figure
3.
4. Fasten the scanner to the stand by inserting the four 6-32 x ½ inch
screws into the four holes in the scanner’s case.