Filter
Top Products
Attaching the Scanner to the Stand and Work Surface
The scanner can be positioned in a vertical orientation with the Metrologic stand (Part #45478).
To attach the unit to the stand and work surface purchase the following: four 6-32 x ½"
(maximum length) machine screws and two (2) #10 pan head or two (2) #8 countersunk wood
screws. (Refer to figure 1)
1. Lay the scanner face down on a clean cloth to prevent any scratches from occurring
on the output window. Position the scanner so the red and green LEDs are pointed
toward you.
2. Lay the stand on the scanner with the angled bracket pointing up and toward you.
3. Align the four clearance holes to the four holes in the scanner’s case. Fasten the
scanner to the stand by inserting the four 6-32 x ½" screws into the four holes in the
scanner’s case.
4. Drill two holes into the work surface that correspond with the holes in the
216mm - 96mm (8.5" x 3.80") base of the stand.
5. Use two pan head or countersunk wood screws to attach the scanner and stand to the
work surface.
5.00 in.
3.50 in.
1.90 in.
3
4 & 5 2
1
Figure 1: Stand Installation
5