Metrologic Instruments MS3780 Scanner User Manual


 
8
INSTALLATION
IBM 46xx or OCIA
1. Turn off the host device.
2. Plug the male 10-pin RJ45
end of the MVC cable into the
10-pin socket on the MS3780.
3. For IBM:
Connect the other end of the
MVC cable to Port 9 of the
host device.
For OCIA:
Connect the other end of the
MVC cable to the appropriate
communication port on the host
device.
4. Turn on the host device.
When the scanner first receives power the white LED will flash, one
blue LED will turn on and the scanner will emit one beep.
Plugging the scanner into the serial port of the PC does not guarantee
that scanned information will appear at the PC. A software driver and
correct configuration setting are also required for proper
communication to occur.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner
must meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC
60950.
To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm
EN/IEC 60950, the power source should meet applicable performance requirements for
a limited power source.
Figure 8. IBM (above), OCIA (below)