Filter
Top Products
3
QUICK START
1. Connect the 10-pin RJ45 male connector into the jack on the Cubit™
IS6520/MS6520. You will hear a ‘click’ when the connection is made.
2. Connect the L-shaped plug of the power supply into the power jack on the
PowerLink cable.
3. Connect the power supply into an AC outlet. Make sure the AC input
requirements of the power supply match the AC outlet.
4. When the IS6520 is ready to scan, the green LED will turn on, the red LED
will flash and the scanner will beep once.
5. Place a bar code in front of the scanning window. The scanner will beep
once and flash the red LED if the bar code was successfully decoded.
NOTE: Cubit™ is shipped from the factory programmed with default
settings. Refer to the MetroSelect
®
Programming Guide for
instructions on how to configure the scanner.
Ž
Œ
•
•
•