Metrologic Instruments MS700i Scanner User Manual


 
12
Figure 2
Installation of the MS700 Series Stand
The following are components used to build the MS700 Series stand
(MLPN: 45483):
1 Shoe Mount 4 Four Wood Screws
2 Stand Cover 5 One Machine (¼-20) Screw
3 Stand Base 6 Internal Lock Washer
7 Flexible Shaft
1. Use the 2½ inch x 2½ inch stand base to mark the position for pilot
holes.
2. Use the four wood screws to secure the base to the work surface.
3. Position the stand cover on top of the stand base.
4. Screw the flexible shaft to the stand base.
5. Place the internal lock washer on top of the flexible shaft and then
screw the shoe to the shaft with the machine screw.