Filter
Top Products
8
INSTALLING THE SCANNER TO THE HOST SYSTEM
Integrated USB: Full Speed (MS95x4-40)
Low Speed POS (MS95x4-39)
Low Speed HID (MS95x4-38)
1. Turn off the host system.
2. Connect the 10-pin RJ45 male connector
of the USB cable into the jack on the
Voyager
PDF. You will hear a ‘click’ when
the connection is made.
3. Connect the other end of the USB cable to
the host USB port.
4. Turn on the host system.
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. The scanner is shipped from the factory preconfigured with
default settings. Please refer to the MetroSelect Single-Line
Configuration Guide (MLPN 00-02544) or MetroSet2’s help files for
instructions on changing the scanner’s configuration. In addition, please
check that the scanner and host system are using the same
communication protocol.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950.
To maintain compliance with standard CSA-C22.2 No. 60950-00/UL 60950 and norm EN/IEC
60950, the power source should meet applicable performance requirements for a limited
power source.
Figure 7.