Filter
Top Products
29
value is set to enable all ports.
- idto The duration of two pressed digits in dial mode
- eod: Digit type of end of dialing. ( 0:No end of dialing, 1:[*] button,
2:[#]button )
- seizure line seizure mode.
None (0): When calling from IP side, choose L1 every time if it is
available.
UCD (1): When calls from IP side, choose L1 for the first time,
and L2 for the 2nd time, (cyclic)
Note: Do not enable this function together with group (please refer to 5.18).
- 2nddial This command is necessary for setting one time dial method use.
While user would like to skip 2nddial process, VoIP FXO
gateway must close 2nddial and set as 0 (2nddial off). The
default value is set as 1 (2nddial on).
- drule This command only works while 2nddial is off. When user would
like to make an outgoing call or receive an incoming call shortly,
it is necessary to set the following three commands belonged to
drule.
z drop: drop the dial digit.
z insert: insert the dial digit
z filter: filter the dial digit.
Note:
1. out: Through VoIP FXO gateway to dial out to another Gateway’s e164
number. When making an outgoing call, it is necessary to set three
commands in order, filter, insert then drop.
Example: sysconf –drule out_filter 002886 out_insert 0 out_drop 02
2. in: Through pass VoIP FXO gateway in order to connect with PSTN / PBX
side. When making an incoming call from other Gateway, three commands
is necessary to be set in order, drop, insert, then filter.
Example: sysconf –drule in_drop 002886 in_insert 0 in_filter 02
3. While the specified digit would like to be deleted, use the character x
instead of any digits have configured.
-askpin 0:disables ASKPIN function
1: enables ASKPIN function, and apply to the whole unit. Every
channel uses the same PINCODE.
2: enables ASKPIN function, and apply to each channel
respectively. Every channel uses a different pincode.
-ring To set when dial in VoIP FXO gateway from PSTN side, VoIP
FXO gateway will pick the call immediately or rings for specific
times before picks up.
0: pick up immediately
1-5: times of ring before VoIP FXO gateway picks up.
- callalive Call Alive function (1 = ON; 0 = OFF). The function is used to
check if the opposite party is alive when connection is
established. When CallAlive is activated, VoIP FXO gateway will
send H.245 RoundTripDelay message to other party, and wait