Filter
Top Products
4
Chapter 2 Hardware Installation
2-1 Quick Installation
• The MIL-S800 should be placed in a well-ventilated room with proper temperature and humidity.
• Do not place the unit near water.
• The maximum distance between the port to the standard network interface is 100 meters.
• For desktop installation, ensure the surface is clean, smooth, level and sturdy. Apply self-adhesive rubber
feet to the bottom of the switch near the corners.
• For wall installation, place two screws securely into the wall. Slide the cross recesses on the bottom of the
MIL-S800 onto the screws.
• For mounting the MIL-S800 on a metal surface, install magnets as shown in instructions and apply to
surface.
• Visually check that the power cord is not damaged. Plug the female end of the cord into the rear of the
MIL-S800 and the male end (power converter) into a power outlet.
• Do not plug a phone jack connector into any RJ-45 port. This may cause damage. Use only twisted-pair
cables with RJ-45 connectors that conform to FCC standards.
Figure 4. Installation of switch