Filter
Top Products
UNINET IMAGING INC. • MINOLTA
®
MAGICOLOR 5430 CARTRIDGE REMANUFACTURING INSTRUCTIONS
REMOVING THE CORONA WIRE ASSEMBLY
19. Remove the corona wire by pushing it towards the opening
on the gear train side. This will allow you to lift one side of it for
easy removal.
20. Corona wire assembly removed.
REMOVING THE OPC
17. Once the OPC drive gear support plate has been removed, it
will allow movement for the drum axle and will simplify the
removal of the OPC.
Note: the drum is secured on the axle with pressure. It will take
some force to remove.
18. Picture of OPC drum removed.
Note: It will not be necessary to remove the drum axle but it can
easily removed by angling the axle and pulling it out of its sup-
port.
Wipe the OPC using drum cleaning solution, cover, and set aside.
© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.
www.uninetimaging.com/technical.asp
11124 Washington Blvd., Culver City, California USA 90232 • Ph +1 310 280 9620 • Fx +1 310 280 0533 • techsupport2@uninetimaging.com
1. PUSH IN
2. THEN PULL OUT