Minuteman UPS CPE 3000 Power Supply User Manual


 
4
NOTICE: This equipment has been tested and found to comply with the limits
for a Class A computing device in accordance with the specifications in Subpart
J of Part 15 of FCC Rules and the Class A limits for radio noise emissions from
digital apparatus set out in the Radio Interference of the Canadian Department
of Communications. These limits are designed to provide reasonable
protection against such interference in a residential installation. This equipment
generates and uses radio frequency and if not installed and used properly, that
is, in strict accordance with the manufacturer's instructions, this equipment may
cause interference to radio and television reception. If this equipment does
cause interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
A. Re-orient the receiving antenna.
B. Relocate the computer with respect to the receiver.
C. Move the computer away from the receiver.
D. Plug the computer into a different outlet so that the computer and receiver
are on different branch circuits.
E. Shielded communications interface cables must be used with this product.
WARNING
Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to operate
the equipment.
Receiving Inspection
After removing your MINUTEMAN UPS from its carton, it should be inspected for
damage that may have occurred in shipping. Immediately notify the carrier and
place of purchase if any damage is found. Warranty claims for damage caused by
the carrier will not be honored. The packing materials that your UPS was shipped in
are carefully designed to minimize any shipping damage. In the unlikely case that the
UPS needs to be returned to MINUTEMAN, please use the original packing material.
Since MINUTEMAN is not responsible for shipping damage incurred when the
system is returned, the original packing material is inexpensive insurance. PLEASE
SAVE THE PACKING MATERIALS!
NOTE: These UPSs are shipped with the batteries disconnected. The batteries
must be connected before putting these UPSs into service. Refer to Chapter 3 for
Connecting the Batteries.
5
Para Systems Life Support Policy
As a general policy, Para Systems Inc. (Para Systems) does not
recommend the use of any of its products in life support applications where
failure or malfunction of the Para Systems product can be reasonably
expected to cause failure of the life support device or to significantly affect
its safety or effectiveness. Para Systems does not recommend the use of
any of its products in direct patient care. Para Systems will not knowingly
sell its products for use in such applications unless it receives in writing
assurances satisfactory to Para Systems that (a) the risks of injury or
damage have been minimized, (b) the customer assumes all such risks,
and (c) the liability of Para Systems Inc. is adequately protected under the
circumstances.
Examples of devices considered to be life support devices are neonatal
oxygen analyzers, nerve stimulators (whether used for anesthesia, pain
relief, or other purposes), auto transfusion devices, blood pumps,
defibrillators, arrhythmia detectors and alarms, pacemakers, hemodialysis
systems, peritoneal dialysis systems, neonatal ventilator incubators,
ventilators for both adults and infants, anesthesia ventilators, and infusion
pumps as well as any other devices designated as “critical” by the United
States FDA.
Hospital grade wiring devices and leakage current may be ordered as
options on many Para Systems UPS systems. Para Systems does not
claim that units with this modification are certified or listed as Hospital Grade
by Para Systems or any other organization. Therefore, these units do not
meet the requirements for use in direct patient care.
Chapter One: Introduction
Thank you for purchasing a MINUTEMAN power protection product. It has
been designed and manufactured to provide many years of trouble free
service.
Please read this manual before installing your CPE On-Line Series UPS,
models CPE 1000, CPE 2000, CPE 3000,
as it provides important
information that should be followed during installation and maintenance of
the UPS and batteries allowing you to correctly set up your system for the
maximum safety and performance. Included is information on customer
support and factory service if it is required. If you experience a problem
with the UPS please refer to the Troubleshooting guide in this manual to
correct the problem or collect enough information so that the MINUTEMAN
Technical Support Department can rapidly assist you.