English
English-11
Specifications LCD51VM Monitor
Monitor Specifications AccuSync LCD51VM Monitor Notes
LCD Module Diagonal: 38.1 cm/15 inches Active matrix; thin film transistor (TFT)
Viewable Image Size: 38.1 cm/15 inches liquid crystal display (LCD); 0.297 mm dot
Native Resolution (Pixel Count): 1024 x 768 pitch; 250 cd/m
2
white luminance, 400/
450:1 contrast ratio, typical.
Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms
Sync: Separate sync.TTL Level (Positive/Negative)
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
Display Colours Analog input: 16,777,216 Depends on display card used.
Synchronization Range Horizontal: 31.5 kHz to 60 kHz Automatically
Vertical: 56 Hz to 75 Hz Automatically
Viewing Angle Left/Right: -60°/+60°(CR>10)
Up/Down: -40°/+60°(CR>10)
Resolutions Supported Landscape: 720 x 400*
1
: VGA Some systems may not support all
640 x 480*
1
@ 60 Hz to 75 Hz modes listed.
800 x 600*
1
@ 56 Hz to 75 Hz NEC-Mitsubishi Electronics Display cites
832 x 624*
1
@ 75 Hz recommended resolution at 75 Hz for
1024 x 768 @ 60 Hz to 75 Hz..................... optimal display performance.
Active Display Area Horizontal: 304.1 mm
Vertical: 228.1 mm
Speakers Practical Audio Output: 1.0 W + 1.0 W
Power Supply 100 - 240 V ~ 50/60 Hz
Current Rating 0.45 - 0.25 A
Dimensions Landscape: 347.4 mm (W) x 341.9 mm (H) x 168.5 mm (D) (with stand)
347.4 mm (W) x 296.2 mm (H) x 53.9 mm (D) (without stand)
Weight 3.0 kg
Environmental Considerations
Operating Temperature: 5 °C to 35 °C
Humidity: 30% to 80%
Altitude: 0 to 3,658 m
Storage Temperature: -10 °C to +60 °C
Humidity: 10% to 85%
Altitude: 0 to 12,192 m
*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is
normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on
the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
NOTE: Technical specifications are subject to change without notice.