Filter
Top Products
6
[Example 3] When checking the TINT setting (when the TINT is set to +10). (Figures and symbols enclosed in
quotation marks are ASCII codes.):
Sending commands
from the PC, etc.
Status code
from the projector
Description
30 30 53 0D
‘0’ ‘0’ ‘S’
‘ ’
Command for checking the TINT
setting
30 30 53 2B 31 30 0D
‘0’ ‘0’ ‘S’ ‘+’ ‘1’ ‘0’ ‘
’
Check result (+10)
• To set TINT at 0, enter +00. (-00 is invalid.)
[Example 4] When setting the REFERENCE of GAMMA MODE-USER1 to CINEMA (+2), ADJUST MODE to RED (R),
HIGH to -2, MID to +3 and LOW to 0. (Figures and symbols enclosed in quotation marks are ASCII
codes.):
* There is no command for selecting ALL for ADJUST MODE. Even when you want to set all the
three colors to the same value, send a command for each of R, G, and B respectively.
Sending commands
from the PC, etc.
Status code
from the projector
Description
30 30 47 53 55 31 52 2B 32 2D 30 32 2B 30 33 2B 30 30 OD
‘0’ ‘0’ ‘G’ ‘S’ ‘U’ ‘1’ ‘R’ ‘+’ ‘2’ ‘-’ ‘0’ ‘2’ ‘+’ ‘0’ ‘3’ ‘+’ ‘0’ ‘0’ ‘ ’
Command for setting GAMMA
MODE-USER1
30 30 47 53 55 31 52 2B 32 2D 30 32 2B 30 33 2B 30 30 OD
‘0’ ‘0’ ‘G’ ‘S’ ‘U’ ‘1’ ‘R’ ‘+’ ‘2’ ‘-’ ‘0’ ‘2’ ‘+’ ‘0’ ‘3’ ‘+’ ‘0’ ‘0’ ‘ ’
Command receipt confi rmation
(Command echo back)