Mitsubishi Electronics SA51 Projector User Manual


 
EN 12
Adjustment foot
screen
Preparing the projector for operation
Getting ready for projection
1. Connect the power cord provided to the projector.
2. Connect the power cord to the wall power outlet.
3. Remove the lens cap.
Warning:
Do not look directly into the lens when projector is
ON.
The lens cap is for protecting the lens. If you leave
the power on with the cap on, the cap may be warped.
Please remove the lens cap when you turn the power
on.
This projector is equipped with the power cords for
both U.S. and Europe. Use the appropriate power
cord for your country.
A three-pin grounding type power plug is used with
the projector. Do not remove the grounding pin on
the power plug. If you are unable to insert the plug
into the outlet, contact your electrician to replace
your A/C outlet.
The supplied power cord for U.S. is used for 120V
only. Never connect to any outlet or power supply
having a different voltage or frequency. If you
connect to the power supply having a different
voltage, please use the appropriate power cord.
Use 100-240V AC 50/60Hz correct voltage other-
wise it may lead to fire or electric shock.
Do not place any objects on the power cord, and keep
the projector away from heat sources to avoid dam-
aging the power cord. A damaged power cord can
cause fire or electric shock.
Do not modify or alter the power cord otherwise it
may cause fire or electric shock.
Contact your dealer if the cord is damaged.
Caution:
Plug in firmly and unplug by holding the plug, not
by pulling the cable out.
Do not plug in or out with wet hands. It may cause
an electric shock.
Adjusting the angle of projection
For the best result, project onto a flat screen with a 90
degree angle to the floor. If necessary, tilt the projector
by adjusting two foot adjustments on the bottom of the
projector.
1. Lift the projector to the appropriate angle.
2. Press the Front height adjuster button, this will al-
low the adjustment foot (up and down) to slide out
to the position.
3. Release the Front height adjuster button to lock the
feet in that position.
After using the projector
4. Return the adjustment foot (up and down) into the
projector by pressing the Front height adjuster but-
ton.
When the left and right angles are different
Adjust the angles with adjustment feet (right and left),
which are on the bottom of the projector.
Important:
Screen on a flat wall with a 90˚ angle to the floor.
Align projector to produce a full screen display as
illustrated on page 9.
The distance from the projector to the screen must
be compatible with screen size chart on page 9.
Note the distance from the screen chart.
A
djustment foot
(up and down)
Front height
adjuster button
Adjustment foot
(right and left)