EN-4
WARNING:
Unplug immediately if there is
something wrong with your product.
Do not operate if smoke, strange noise or odor
comes out of your product. It might cause fire or
electric shock. In this case, unplug immediately
and contact your dealer.
Never remove the cabinet.
This product contains high voltage circuitry. An
inadvertent contact may result in an electric
shock. Except as specifically explained in the
Owner’s Guide, do not attempt to service this
product yourself. Please contact your dealer when
you want to fix, adjust or inspect the product.
Do not modify this equipment.
It can lead to fire or electric shock.
Use the optional specified power supply
cord.
This apparatus must be grounded.
Place the product more than 5 cm (2 in.)
from the wall (except at the rear) to
prevent blocking the intake, exhaust slots
and ventilation of this product because
hot air comes out of it.
Carry the product by all four handles,
not by two handles.
Do not use the product under the
following circumstances, which may
cause fire or electric shock.
• in a dusty or humid place
• near a heater
• in a oily, smoky or damp place
• in direct sunlight
• with high temperature, such as the closed car
• where the temperature is lower than 10˚C
(50˚F) or higher than 35˚C (95˚F)
• for VS-50XLF50U, VS-50XLWF50U, VS-
67XLF50U, VS-67XLWF50U the temperature
is lower than 10˚C (50˚F) or higher than 30˚C
(86˚F)
CAUTION:
Battery replacement of the optional remote
control R-XL50TX
•Improper use may result in fire, injury, or spread
dirt due to leakage, heat generation, or explosion.
• Replace all the batteries with new ones. Use two
AA batteries (R6P).
• Load the batteries with their (+) and (-) sides
correctly.
• Load the batteries from (-) sides first.
NOTE:
This symbol mark is for EU countries only.
This symbol mark is according to
the directive 2002/96/EC Article 10
Information for users and Annex IV.
Your MITSUBISHI ELECTRIC product is de-
signed and manufactured with high quality mate-
rials and components which can be recycled and
reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed
of separately from your household waste.
Please, dispose of this equipment at your local
community waste collection/recycling centre.
In the European Union there are separate collec-
tion systems for used electrical and electronic
product.
Please, help us to conserve the environment we
live in!
Warning:
This is class A information technology equipment. When used in a household environment, this product
may cause radio interface. In such a case, the user may be required to take suitable countermeasures.
COMPLIANCE NOTICE OF FCC
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the in-
struction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus
as set out in the interference-causing equipment standard entitled “Digital Apparatus”, ICES-003 of the
Department of Communications.
Changes or modifications not expressly approved by Mitsubishi could void the user's authority to operate
this equipment.
COMPLIANCE NOTICE OF INDUSTRY CANADA
This Class A digital apparatus complies with Canadian ICES-003.
COMPLIANCE NOTICE OF EC DIRECTIVE
This data display complies with requirements of 89/336/EEC, 2006/95/EC and 93/68/EEC. The require-
ments of susceptibility have chosen at a level, that makes interference free operation possible in living
areas, office areas and light industry, related to indoor and outdoor operation. All places of operation are
related to the public low voltage power supply.
This is a equipment of Class A. This device could cause interferences in residential areas; in the case of
interferences it can be demand from the user to provide appropriate solutions and pay for it.