Mitsubishi Electronics XL1X S L 2 Projector User Manual


 
EN 14
30
To operate projector power ON (Continue)
Turning off the projector
7. Press the POWER button.
The message POWER OFF? YES : PRESS AGAIN
appears on the screen.
To exit from this mode, press any button except
the POWER button. (Some buttons on the remote
control do not work for exit from this mode.)
8. Press the POWER button again.
The light source lamp will be turned off.
Pressing the POWER button second time will shut
off the light source lamp, but the exhaust fan con-
tinues to operate for 60 seconds to cool down the
light source lamp and LCD panels. In this time, the
lamp indicator will be turned off.
9. Turn off the main power switch. When turning off
the main switch, the POWER indicator turns off.
In cases where the main power switch is acciden-
tally turned off when either the intake/exhaust
fan or the power source lamp is in operation, allow
the unit to cool down for 10 minutes with the
power turned off. Repeat step 3 when turning on
the power source lamp. If the lamp does not turn
on immediately, repeat this step two or three
times. Replace the lamp if it should still fail to
turn on.
AUTO POSITION button
When the source is selected to COMPUTER and the
image is not in the right place, follow as shown below.
1. Set screen to the brightest display as possible
(e.g., full-screen display of the Trash window).
2. If the screen saver is running, turn off the screen saver.
3. Press the AUTO POSITION button.
If the image is still not in the right place, adjust
the image position by using the SIGNAL menu.
The sound from the speaker
The sound from the speaker is mono.
The output sound is selected by changing the
setting of AUDIO MODE in the FEATURE menu.
See page 17 for details.
The volume from the speaker
Press the volume + or button to change the volume
from the speaker.
The volume control bar will appear on the screen.
The volume control bar will disappear about 4
seconds after releasing the volume buttons.
The volume buttons do not work when MENU
selection bar or MENU is displayed.
AV mute
Image and audio are temporarily erased with press-
ing the MUTE button. To restore the image and
audio to the normal mode, press the MUTE button
again.
If the MUTE MODE in the INSTALLATION menu is
set to LOGO, the splash screen will appear by pressing
the MUTE button.
The lamp mode becomes LOW during muting.
Therefore, the display of LOGO will darken, which
isnt a failure.
Muting will be cancelled in 3 hours automatically for
the purpose of protecting devices. However, when the
mute mode has been set to LOGO, muting wont be
cancelled.
ANAMORPHIC mode
When playing DVD discs containing data of letterboxed
image, press the 16:9 button. Exit the ANAMORPHIC
mode, by pressing the 16:9 button again.
Caution:
When you have finished using this equipment, wait
60 seconds for the exhaust fans to stop. Then turn off
the main switch and unplug the power cable from the
wall outlet, for safety purposes.
After the lamp is turned off, the lamp cannot be
switched on again for 60 seconds as a precaution-
ary measure. If you wish to turn on the projector
again, wait until the indicator is off then press the
POWER button.
The exhaust fan rotates faster when the tempera-
ture around the projector rises.
When the temperature around the projector becomes
too high, the sign TEMPERATURE!! blinks red on
the screen. If the temperature stays too high, the lamp
will be shut off automatically .