Mitsubishi Electronics XL5U Projector User Manual


 
1
1) Interface
Controling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions :
Turning the power ON or OFF
Changing input signals
Inputting commands by pressing the buttons on the control panel and remote control
•Menu setting
Connection
to SERIAL terminal
to SERIAL port
RS-232C cable
D-SUB 9P
8P
Important:
Make sure that your computer and projector are turned off before connection.
Boot up the computer first, and then plug the power cord of the LCD projector.
(If you do not follow this instruction, the Comport may not function.)
There are two RS-232C terminals on the projector. You can use either of them.
Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.
PROTOCOL RS-232C
BAUD RATE 9600 [bps]
DATA LENGTH 8 [bits]
PARITY BIT NONE
STOP BIT 1 [bit]
FLOW CONTROL NONE
This projector uses RXD, TXD and GND lines for RS-232C control.
For RS-232C cable,the reverse type cable should be used.
2) Control command diagram
The command consists of the address code, function code, data code, and end code. The length of the command
varies among the functions.
Address code Function code Data code End code
HEX 30h 30h Function Data 0Dh
ASCII '0' '0' Function Data
[Address code] 30h 30h (In ASCII code, '0' '0') fixed.
[Function code] A code of each fixed control move.
[Data code] A code of each fixed control data (number) and not always indicated.
[End code] 0Dh (In ASCII code, ' ') fixed.
LCD Projector
XL8U / XL5U / SL4SU