Filter
Top Products
Wireless Network Access Point
Instant Wireless
TM
Series
Chapter 3: Getting to Know the
Wireless Network Access Point
The Access Point’s ports, where a network cable is connected, are located on
the Access Point’s rear panel.
Dipole Antenna
Connectors These two round connections are where the antennae are
connected to the Access Point.
LAN This LAN (Local Area Network) port connects to
Ethernet network devices, such as a hub, switch, or
router.
Power The Power port is where you will connect the power
adapter.
Reset Button There are two ways to Reset the Access Point’s factory
defaults. Briefly press the Reset Button for approximately
ten seconds, or use the Password tab of the Access Point’s
Web-Based Utility.
4
The Wireless Network Access Point’s Ports
Figure 3-1
T
Power Red. The Power LED lights up when the Access Point is
powered on.
ACT Green. If the LED is flickering, the Access Point is actively
sending or receiving data to or from one of the devices on the
network.
LINK Amber. The LINK LED serves two purposes. If the LED is
continuously lit up, the Access Point is successfully connect-
ed to a device through the LAN port. If the LED is flicker-
ing, it is an indication of any network activity.
The Wireless Network Access Point’s LEDs
Figure 3-2
Important: Resetting the Access Point will erase all of your settings
(WEP Encryption, Wireless and LAN settings, etc.) and replace
them with the factory defaults.
5