Filter
Top Products
17
Momentum mo8 Manual
Individual Channel Route
IP Address View
Control Panel Functions
Chapter 3
Description of Functions
Pressing F1 will fl ash the IP address of a unit.1.
Toggle F2 to until rou is displayed.1.
Tap F1 to activate rou “edit” mode.2.
Toggle F1 to scroll channels. Toggle F2 to select a channel.3.
Tap F1 to decrease value. Tap F2 in increase value.4.
Press and hold F1 and F2 to execute and save the change.5.
Return to selecting channels or exit by allowing display to time out.6.
Toggle F2 until Vol is displayed.1.
Tap F1 to activate Vol “edit” mode.2.
Toggle F1 to scroll channels. Toggle F2 to select a channel.3.
Tap F1 to decrease value. Tap F2 in increase value.4.
Press and hold F1 and F2 to return to channel selection.5.
On completing channel selection, press F1 & F2 to exit or allow display to time out.6.
To return to the beginning of the menu, allow the display to time out. When the display times out and
when the unit is at idle, the start channel number of the unit’s channel bank will be displayed.
Please note:
The functions in the step by step guide are presented in the same order as the functions 1.
on the unit’s menu structure.
In order to edit a channel, the user must fi rst scroll to the function in need of editing, select 2.
the appropriate channel and make the edit.
Attenuation (Adjustment from 0 - (-128)dB)
Note about Routing:
The number shown on the display will be the fi rst of eight consecutive numbers.•
When an individual channel is given new routing number that is out of sequence, •
the display will show “- - -”. This display makes it easy to identify which mo8 unit
has channel/channels that are out of sequence.
To put channels back into sequential order, toggle F2 to “Chn” and assign that •
sequence a new start channel.