Filter
Top Products
06/08 Rev. AA QUICK REFERENCE
9864
19
Cleaning the Rollers
Cleaning the print roller
Clean the print roller when you see adhesive buildup or dirt on the roller.
1. Turn off the printer and disconnect the power supply.
2. Remove the material and ribbon.
3. Dispenser version only: Remove the dispensing edge to access the print
roller by removing both holding screws (1).
Fig. 2 When using a 64xx dispenser,
remove the dispensing edge to
access the print roller.
4. Unscrew the two thumb screws
on the printhead mounting and rotate the entire printhead mounting
upwards.
P See “Cleaning the Printhead” for more information.
¯
If the printhead needs to be removed, mark the position of the printhead on
the axle, if it is not flushed against the inner or outer plastic ring.
5. Moisten a cloth with isopropyl alcohol and wipe the roller clean. Turn the
print roller with your finger to clean the entire surface.
Fig. 3 Rotate the printhead upwards
before cleaning it.
1
1