Filter
Top Products
English 2
Electronic Equipment (WEEE). Motion Computing
Incorporated is a participant in the "Take Back" program
established in the WEEE Directive and assumes full
responsibility for the disposal take back of its products.
• This product is in compliance with Directive 2005/32/EC
of the European Parliament and of the Council set into
force on July 2005. This Directive established the
framework for setting the eco-design requirements for
energy-using products and amending Council
Directives 92/42/EEC, 96/57/EC, and 2000/55/EC of the
European Parliament and of the Council.
• This product is in compliance with Commission
Regulation (EC) No. 278/2009. The Regulation set forth
procedures for implementing Directive 2005/32/EC of
the European Parliament and of the Council with regard
to eco-design requirements for "No-Load" condition
electric power consumption and average active
efficiency of external power supplies. The Motion power
supply meets the requirements and guidelines of the
Commission Regulation (EC) No. 278/2009.
• Motion Computing Incorporated ensures that this
product does not contain any substances proposed for
inclusion to be listed in the Substances of Very High
Concern (SVHC) "Candidate List" (Art. 59.1 of Regulation
No. 1907/2006 updated June 18, 2010) in an individual
concentration of greater than or equal to 0.1% by
weight.
California Proposition 65 notice
This product contains no known materials at levels which
the State of California has found to cause cancer, birth
defects, or other reproductive harm.
Regulatory and safety compliance
The following sections describe regulatory and safety
compliance by country and by region.
Note: To determine which regulatory and safety marks
apply to a specific product, component, or accessory, check
the product label affixed to the product and/or its
components.
Federal Communications Commission
notice (USA)
Electromagnetic Interference (EMI) is any electromagnetic
disturbance that interrupts, obstructs, or otherwise
degrades or limits the effective performance of electronics
or electrical equipment. These emissions can potentially
disrupt, degrade, or otherwise interfere with authorized
electronic emissions, which may include television, AM/FM
broadcasts, cellular services, radar, air-traffic control, and
pagers.
The FCC Rules and Regulations have established Radio
Frequency (RF) emission limits to provide an interference-
free RF spectrum. Many electronic devices, including
computers, generate RF energy incidental to their intended
function and are, therefore, covered by these rules.
Unintentional Emitter per FCC Part 15
The rating label on CL-Series Docking Station and all
accessories show which class (A or B) these devices fall into.
Once you determine the class of the device, refer to the
following corresponding statement and to the FCC notices
in this Safety and Regulatory Guide.
• Class A is a digital device that is marketed for use in a
commercial, industrial or business environment,
exclusive of a device which is marketed for use by the
general public or is intended to be used in the home.
• Class B is a digital device that is marketed for use in a
residential environment notwithstanding use in
commercial, business and industrial environments.
Examples of such devices included, but are not limited
to, personal computers, calculators, and similar
electronics devices that are marketed for use by the
general public.
This device complies with Part 15 of the Federal
Communications Commission (FCC) Rules. Operation is
subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received,
including interference that may cause undesired
operation.
Class A Equipment: This equipment has been tested and
found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference when the equipment is operated in a
residential environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the manufacturer’s
instruction manual, may cause interference with radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in
which case you will be required to correct the interference
at your own expense.
Class B Equipment: This equipment has been tested and
found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference when the equipment is operated in a
residential environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the manufacturer’s
instruction manual, may cause interference with radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television
technician for help.
The following information is provided on the device or
devices covered in this document in compliance with FCC
regulations:
Motion CL-Series Docking Station model number: FWS-DS1
Company name: Motion Computing, Incorporated
8601 Ranch Road 2222, Bldg 2
Austin, TX 78730 USA
Telephone: 512-637-1100
Fax: 512-637-1199