Filter
Top Products
— 4 — — 5 — — 6 —
4. The next window that opens cautions you that although this software
has not passed Windows logo testing, this driver has already been
tested and shown that it can support the Windows OS. Click Continue
Anyway to proceed. Then, click Finish to complete the driver
installation.
4. Installing the UPort 1200/1400/1600 Hardware
WARNING
1. This unit is not meant to be sold to consumers. It will only be shipped
to manufacturers or factories.
2. The DC source should come from a class 2 external adaptor or a 12 to
48 VDC Safety Extra-Low Voltage (SELV) limited power source
(LPS) using a transfer device.
3. This unit should be installed or set up by a qualified service person.
1. Refer to the table below to see if external power is needed for your
UPort. If applicable, connect the UPort to an external power source.
UPort
1250
UPort
1250I
UPort
1410
UPort
1450
UPort
1450I
UPort
1600-8
UPort
1600-16
USB-
powered
√ × √ √ × × ×
external
power
× √ √ √ √ √ √
2. Connect the UPort to the PC using the USB cable.
3. After powering on your PC, Windows 2000/XP/2003 will
automatically detect the UPort.
4. Click Next to start the installation.
5. Select Install the software automatically (Recommended).
6. The next window that opens cautions you that although this software
has not passed Windows logo testing, this driver has already been
tested and shown that it can support Windows OS. Click Continue
Anyway to proceed. Then, click Finish to complete the driver
installation.
7. Repeat steps 4 to 6 until all COM ports are installed.
5. Serial Port Pin Assignments
The serial ports on the UPort 1200/1400/1600 have DB9 male connectors.
Refer to the following table for the RS-232 and RS-422/485 pin assignments.
DB9 Male
Pin RS-232
RS-422/
4-wire RS-485
2-wire
RS-485
1 DCD TxD-(A) ---
2 RxD TxD+(B) ---
3 TxD RxD+(B) Data+(B)
4 DTR RxD-(A) Data-(A)
5 GND GND GND
6 DSR --- ---
7 RTS --- ---
15
69
8 CTS --- ---
Power Input Specifications
UPort 1250: 5 VDC (bus power), 360 mA
UPort 1250I: 12 to 48 VDC, 200 mA (max. in 12 VDC)
UPort 1410/1450: 12 to 48 VDC (external) or 5 VDC (bus power),
260 mA (max. in 12 VDC)
UPort 1450I: 12 to 48 VDC, 360 mA (max. in 12 VDC)
UPort 1600-8: 12 to 48 VDC, 580 mA (max. in 12 VDC)
UPort 1600-16: 100 to 240 VAC,
220 mA (max. in 100 VAC)
Copyright © 2007
Moxa Technologies Co., Ltd.
All rights reserved.
Reproduction without permission is prohibited.
Tel: +886-2-8919-1230
www.moxa.com
Fax: +886-2-8919-1231
support@moxa.com