Filter
Top Products
31
Chapter 3—Driver Installation - Windows NT
Networking.
Click Yes.
9. The Remote Access Setup dialog box appears. Click Add.
10. Each COM port appears in a separate Add RAS Device dialog
box. To add the highlighted device, click OK.
11.The Remote Access Setup dialog box displays again. Repeat
steps 9 and 10 until all modems are added.
12.When all modems have been added (four modems for the
ISI5634PCI-4; eight modems for the ISI5634PCI-8), click
Continue.
13. After bindings have been reviewed and stored, you will be
prompted to re-start your computer. Click Yes.
You have completed installation of modems to COM ports and
configuration of RAS in Windows NT.
Note: By default, Microsoft sets the serial baud rate at 57,600
bps. For improved performance, you can raise the serial baud
rate. To do so, go to Start | Settings | Control Panel. Click on
the Modems icon. Then click on the Properties button of the
Modems Properties dialog box. Reset the Maximum Speed as
needed. A speed of 320,400 bps improves performance
significantly without complications in most cases.