Filter
Top Products
128 MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD
Terminal Adapter AT Commands & S-Registers
Specifies the character used by the TA to escape from data mode and return
to command mode.
S3 Carriage Return Character
Unit: Decimal ASCII code
Range: 0127
Default: 13 (^M)
Specifies the character used by the TA to indicate the end of a command line.
S4 Line Feed Character
Unit: Decimal ASCII code
Range: 0127
Default: 10 (^J)
Specifies the character used by the TA to indicate the end of a status
message.
S5 Backspace Character
Unit: Decimal ASCII code
Range: 032, 127
Default: 8 (^H)
Specifies the character used by the TA to delete the previous character in
command line.
S7 Wait for Connection (Abort Timer)
Unit: 1 second
Range: 0255
Default: 45
Sets Abort Timer delay time, which is the length of time TA waits for a
connection after dialing. If no connection is established during the specified
time, the TA ends the call.
S8 Pause Time for Comma
Unit: 1 second
Range: n=0-255
Default: 2 (= 2 seconds)
S8 sets the length of the pause caused by a comma inserted in a dialing
command. The default setting is 2 seconds, where each unit is one second.
S8 may be set for up to 255 seconds.