Filter
Top Products
English
6. ATTACHING AN ARM 39
6. ATTACHING AN ARM
The LCD monitor can be used with an arm by removing the tilt stand and attaching
the arm or stand to the LCD monitor.
NOTE
z If you will use the arm or stand of other manufacturers, confirm the followings to
the manufacturers before selecting.
– Hole spacing on the arm mounting: 100 mm x 100 mm (VESA compliant)
– Supportable Weight: Total weight of the monitor (without stand) and attaching
equipment such as a cable
– TÜV/GS approved arm or stand
z Please connect cables after attaching an arm stand.
Setup Procedure
1. Hold the center of the stand mounting cover and slide them
rightward or leftward to remove the mounting cover.
2. Lay the LCD monitor down. Do not scratch the panel.
3. Remove the tilt stand by loosening the screws.
(4 pcs of M4 x 15mm)
Stand mounting cover