Filter
Top Products
4
English
TroubleshootingSetting/AdjustmentPrior to use Installation
Connecting Cables
Attention
• When replacing the current monitor with a S2001W/S2201W monitor, be sure to change the PC settings
for resolution and vertical frequency to those which are available for the S2001W/S2201W monitor
referring to the resolution table (back of cover page) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User’s Manual on the CD-ROM.
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
Connectors on
the PC
DVI connector
D-Sub mini 15-pin
connector
Connectors on
the monitor
DVI-I connector
D-Sub mini 15-pin
connector
Stereo mini jack cable (supplied)
Signal cable MD-C87 (supplied)
Digital connection
Analog connection
CD player, etc
Signal cable FD-C39 (supplied)
Audio output
connector
Audio input
connector
3
Plug the power cord into a power outlet and the Power connector on the monitor.
Adjusting Screen Height and Angle
Hold left and right edge of the monitor with both hands, and adjust the screen height, tilt and swivel of the screen to the
best condition for working.
Height adjustable stand
Hold left and right edge of the monitor with both hands to
adjust the screen up, down, left and right directions.
EZ-UP stand
Hold the left and right edges of the monitor with both
hands and adjust the screen angle by moving them
upwards, downwards, or to the left or right.