Filter
Top Products
Chapter 3 Programming with NI-IMAQ
NI-IMAQ User Manual 3-2
©
National Instruments Corporation
Low-Level Functions
The low-level function set supports all types of acquisition and can be
used to:
• Create a custom acquisition sequence or ring
• Create and manage your own buffers
• Set session and interface attributes to adjust image quality and size
• Start a synchronous or asynchronous acquisition
• Extract buffers out of a live acquisition for analysis
• Set up and control triggered acquisitions
Establishing Interface Connections and Sessions
To acquire images using the high-level or low-level functions, you must
first learn how to establish a connection to an interface and create a session.
See the Interface Functions and Session Functions sections in this chapter
for information on how to manage interfaces and sessions, then refer to the
high-level or low-level samples for information on acquiring images.
Interface Functions
Use interface functions to query the number of available interfaces,
establish a connection to, control access to, and initialize hardware such as
the PCI/PXI-1408. All interfaces in NI-IMAQ are specified by a name. By
default, the system creates default names for the number of boards in your
system. These names observe the convention shown in Table 3-1.
You can edit existing or create new interfaces by using the IMAQ
Configuration Utility. You also can use the IMAQ Configuration Utility to
configure the board serial number and the default state of a particular
interface.
Table 3-1.
Interface Naming Convention
Interface Name Board Installed
img0
Board 0
img1
Board 1
... ...
img
n
Board n
UM.book Page 2 Monday, July 13, 1998 9:49 AM