Filter
Top Products
Appendix D Troubleshooting and Common Questions
© National Instruments Corporation D-3 PXI-8461 or PXI-8460 and NI-CAN for Windows NT
How do I connect a CAN cable to my CAN port?
You will need to use an appropriate cable. For information about cabling
requirements for National Instruments CAN hardware, refer to
Appendix B, Cabling Requirements for PXI-8461 High-Speed CAN or
Appendix C, Cabling Requirements for PXI-8460 Low-Speed CAN.
Are interrupts required for the PXI-8461 and PXI-8460?
Yes, one interrupt per board is required.
What do I do if the NI-CAN Diagnostic utility fails with an error?
Refer to the Diagnostic Utility Failures section in this appendix for specific
information about what might cause the NI-CAN Diagnostic utility to fail.
If you have already completed the troubleshooting steps, contact National
Instruments.
How do I use an NI-CAN language interface?
For information about using NI-CAN language interfaces, refer to
Chapter 3, Developing Your Application
,
in the NI-CAN User Manual.
How do I use NI-CAN from within LabVIEW or BridgeVIEW?
For information about using NI-CAN from within LabVIEW or
BridgeVIEW, refer to Chapter 3, Developing Your Application
,
in the
NI-CAN User Manual.
Why does the uninstall program leave some components installed?
The uninstall program removes only items that the installation program
installed. If you add anything to a directory that was created by the
installation program, the uninstall program does not delete that directory
because the directory is not empty after the uninstallation. You must
remove any remaining components yourself.