National Instruments PCI-232/4 Tablet User Manual


 
Using PCI Serial with Linux 14 www.natinst.com
What do I do if FIFOtrigger does not work immediately or causes a
segmentation fault?
Enter the following to recompile
FIFOtrigger_pci.c and rerun
FIFOtrigger. Also, the source code for FIFOtrigger is available for
editing and viewing at
FIFOtrigger_pci.c provided in the
PCI-SERIAL directory.
linux PCI-SERIAL# gcc -O FIFOtrigger_pci.c -o
FIFOtrigger
linux PCI-SERIAL# ./FIFOtrigger <
port number
>
<
rx_trigger
> <
tx_trigger
>
What do I do if rs485 does not work immediately?
Enter the following to recompile
rs485.c. Also, the source code for
rs485 is available for editing and viewing at rs385.c, provided in the
PCI-SERIAL directory.
linux PCI-SERIAL# gcc -O rs485.c -o rs485
What do I do if clockspeed does not work immediately or if it causes
a segmentation fault?
Enter the following to recompile
clock_speed.c and rerun
clockspeed. Also, the source code for clockspeed is available for
editing and viewing at
clock_speed.c, provided in the PCI-SERIAL
directory.
linux PCI-SERIAL# gcc -O clock_speed.c -o clockspeed
linux PCI-SERIAL# ./clockspeed <
port number
> <
high/low
>
What do I do if serialtest does not work immediately or if it causes
a segmentation fault?
Enter the following to recompile
serialtest.c and rerun serialtest.
Also, the source code for
serialtest is available for editing and viewing
at
serialtest.c, provided in the PCI-SERIAL directory.
linux PCI-SERIAL# gcc serialtest.c -o serialtest
linux PCI-SERIAL# ./serialtest <
receive port number
>
<
transmit port number
>
What do I do if serialtest hangs?
Make sure the interface is seated correctly and tighten the screw that holds
the interface in place. Also, make sure the cables are attached to the correct
ports. In some cases,
serialtest hangs if the transceiver modes
(PCI-485) are not set. Try setting both transmit and receive ports to
transceiver mode 0 (Four-Wire Mode).