NDC comm HWB3163 Network Card User Manual


 
10
Operational Characteristics
See the HWB3163-EVAL data sheet, Intersil File #4794, for
more detailed specifications.
References
For Intersil documents available on the internet, see web site
www.intersil.com/
Intersil AnswerFAX (321) 724-7800.
[1] HWB3163-EVAL Data Sheet, Intersil Corporation,
AnswerFAX Doc. No. 4794.
[2] AN9850 Application Note, Intersil Corporation,
“Complementary Code Keying Made Simple”,
AnswerFAX Doc. No. 99850.
Notices
Electronic Emission Notices
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired operation.
FCC Radio Frequency Interference Statement
The wireless LAN PC card is subject to the rules of the
Federal Communications Commission (FCC). This card is
considered an intentional radiator as per the FCC guidelines.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference toradio or television reception, whichcan be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
Consult the dealer or an experienced ratio/TV technician for help
WARNING! Any changes or modifications of equipment not expressly
approved by Intersil could void the user’s authority to operate the equipment.
Absolute Maximum Ratings Operating Conditions
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 4.0V (Max)
Storage Temperature (Note 1) . . . . . . . . . . . . . . . . . . -20
o
C to 65
o
C
Temperature Range. . . . . . . . . . . . . . . . . . . . . . . . 0
o
C T
A
55
o
C
Supply Voltage Range . . . . . . . . . . . . . . . . . . . . . . . . . . 3.0V to 3.6V
Caution: These are the absolute maximum ratings for the PC Card product. Exceeding these limits could cause permanent damage to the card.
NOTE:
1. All temperature references refer to ambient conditions.
TABLE 2. GENERAL SPECIFICATIONS
SPECIFICATION VALUE
Targeted Standard IEEE 802.11
Data Rate 1Mbps DBPSK
2Mbps DQPSK
5.5Mbps CCK
11Mbps CCK
Range (11Mbps Data Rate) 120ft (37M) Indoor (Typ)
400ft (122M) Outdoor (Typ)
Center Frequency Range 2412MHz - 2484MHz
Step Size 1MHz
IF Frequency 374MHz
IF Bandwidth 17MHz
RX/TX Switching Speed 2µs (Typ)
Average Current without
Power Save
2% Transmit, 98% Receive
187mA (Typ)
Average Current with Power
Save
2% TX, 8% RX, 90% Standby
43mA (Typ)
Current in Continuous TX
mode
300mA (Typ)
Current in Continuous RX
mode
185mA (Typ)
Standby Current 25mA (Typ)
Mechanical Type II PC Card, with Antenna
Extension
Output Power +11.5dBm (Typ)
Transmit Spectral Mask -30dBc at First Side Lobes
Antenna Interface SMA, 50Ω (for testing only)
Dual Diversity Printed Antenna
Application Note 9864