Filter
Top Products
A Phillips-head screwdriver is required for installing the NEC SuperScript 1800 IrDA and Serial Interface Upgrade Kit.
Accessing the Printer Controller Board
Installing the IrDA Interface Card and Adapter
1. Turn off the printer.
2.
Pull-out 500-sheet Cassette
(A)
.
3. Disconnect all cables from printer.
4. Position the printer so right-side can be accessed.
5. Remove screws from side-panel then open back-
panel
(B)
.
6. Pull tab to release side-panel
(C)
.
7. Slide side-panel towards back
(D)
.
8. Rotate side-panel away from printer (assure wire-snaps
on the parallel port are not in way), then lift away
(E)
.
9. Loosen top screw of metal controller board cover, remove
remaining 4 screws, then remove cover
(F)
.
1. Position the printer so you have access to the back.
2.
Remove screw from the metal back plate
(A)
.
3. Insert IrDA Interface Card into printer
(B)
.
4. Connect card with socket on controller board
(C)
.
5. Use screw, removed in Step 2, to fasten the card
(D)
.
6. Use previous procedure as guide to replace printer
side-panel, 500-sheet Cassette, and printer cables.
7. If only using the serial connection, go to Step 10.
8. Connect IrDA adapter to IrDA port
(E)
.
9. Aim adapter at your computer’s IrDA sensor. Do not
allow more than 3 feet of separation
(F)
.
10. For more information about installing the IrDA driver
or using the serial port, see Chapter 8 of the SuperScript
1800 User’s Guide.
A
BC
DE
F
B
D
A
F
E
3 feet or less
C
Connect to
socket on
controller
board
NEC
S
UPER
S
CRIPT
1800
I
R
DA
AND
S
ERIAL
I
NTERFACE
U
PGRADE
K
IT
— I
NSTRUCTIONS
P
ART
N
O
. 808-878300-011A