NEC A900 Computer Monitor User Manual


 
Quick Start
Figure A.1
3
15-pin mini D-SUB
Captive Signal Cable
To attach the MultiSync
®
A900
monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync A900 Macintosh cable adapter (not
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync A900
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync A900 Macintosh cable adapter, call
NEC Technologies at (800) 820-1230.
4. For download information on the Windows
®
95/98 INF file for your
MultiSync A900 monitor, refer to the References section of this User’s Manual.
5. Connect one end of the power cord to the MultiSync A900 monitor and the
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
78133961.MultiL 9/10/98, 12:02 PM5