Filter
Top Products
Quick Start
Figure A.1
2
To attach the MultiSync
®
E900+
™
monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync E900+ Macintosh cable adapter (not
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync E900+
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync E900+ Macintosh cable adapter, call
NEC Technologies at (800) 820-1230.
4. For download information on the Windows
®
95 INF file for your MultiSync
E900+ monitor, refer to the References section of this User’s Manual.
5. Connect one end of the power cord to the MultiSync E900+ monitor and the
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
78133521 5/15/98, 2:16 PM4