Filter
Top Products
28
Sound bar Setup
To attach the MultiSync sound bar 70 to your LCD1770NXM, follow these
instructions.
Note: this setup is only for the LCD1770NXM. If you have purchase
an LCD1770V or LCD1770NX, please move to the next page.
1.
Turn off the computer.
2. Place hands on each side of the display to tilt up the panel and then lift up to the
highest position.
3.Use the two thumb screws included to attach the MultiSync sound bar 70 to the display
(Figure SB.1).
4.Turn the volume control down on the
MultiSync
soundbar 70 (Figure SB.2).
5.
Connect the light blue color audio cable plug to the light blue jack of MultiSync sound
bar 70 (Figure
SB.1
). Connect the other end of the audio cable into the back of your
computer.
NOTE: Headphones may be connected to the headphones jack on the right side of the
MultiSync sound bar 70 (Figure SB.2). Headphones can be purchased from your local
electronics store.
6.Connect the DC power cable of sound bar 70 to DC-OUT terminal of display (Figure
SB.1).
7.You are now ready to move to the next step in setting up your MultiSync LCD.
VOL.
Headphone Jack
Volume Control
VOL.
Figure SB.2
Audio
Cable
DC Power
Cable
Thumb
Screw
Thumb
Screw
DC-OUT Terminal
of Display
Figure SB.1
LCD17PISAManual080604.p65 8/6/04, 5:15 PM28