Filter
Top Products
- 51 -
4-2. Installing/Removing SFP Module
After the FC Switch Module is installed in the Blade Enclosure (SIGMABLADE), install SFP
modules on external ports to connect with fibre channel peripherals. SFP module NF9330-SF02 is
only available.
For N8406-019, four external ports, or ports 17, 18, 19 and 20 are available.
Ports 21, 22, 23, and 0 are unavailable.
For N8406-020, eight external ports, or ports 17, 18, 19, 20, 21, 22, 23 and
0, are available.
If an FC Switch Module with SFP modules installed are stored or carried,
always put the dust-proof covers attached to the SFP modules on them to
protect the FC connectors from dust.
CAUTION
Do not view laser directly.
The NF9330-SF02 SFP module confirms to laser safety standard class 1.
However, do not view the laser within a short distance of up to 20 cm. Failure to
follow this instruction may have bad influence on your pupils. Do not look in the
port of each SFP module during operation. If an SFP module is not connected
with an optical fiber cable, always put the attached dust-proof cover (rubber cap)
on the connector terminal of the SFP module to protect it.
Installation Procedure
To install an SFP module on the FC Switch Module, insert it to an SFP port to the depth.
SFP modules authorized by NEC are only available.
N8406-*** FC Switch Module
NF9330-SF02 SFP module
SFP port
Insertion
direction