Connecting PC as monitor
VGA/DTV INPUT
1. Connect the VGA IN cable
(D sub jack) from the
monitor output socket of
the PC to the PC/DTV
input socket of the set.
2. Connect the Audio cable
from the PC to the PC
Audio IN of the set.
3. Press the TV/AV button to
select PC mode.
4. Switch on the PC, and the PC screen appears on the set.
The set can be operated as the PC monitor.
Resolution
Note:
a. If the set is cold, there may be a small “flicker” when the set is switched on.
This is normal, there is nothing wrong with the set.
b. Some dot defects may appear on the screen, like Red, Green or Blue spots.
However, this will have no impact or effect on the monitor performance.
c. When resolutions are displayed that are not native to the panel resolution,
text may appear choppy or lines may appear to be bold or thicker than others.
To minimize, choose a resolution similar to the panel.
Connecting PC as monitor
Picture adjustment
You can adjust picture Contrast, Brightness, Temperature,
Horizontal/Vertical position, Clock, Phase, Auto and Reset
as you prefer.
1. Press the TV/AV button to select the PC mode.
2. Press the MENU button.
3. Press the PR
xy
button to select the desired
picture item.
4. Press the VOL
Ïq
button to make appropriate
adjustments.
Contrast
This function is to adjust picture to light/dark.
Brightness
This function is to adjust brightness of picture.
Temperature
Temperature is a measure of the warmth of the image color.
Horizontal Position/Vertical Position
This function is to adjust picture to left/right and up/down
as you prefer.
Clock
This function is to minimize any vertical bars or stripes visible
on the screen background. Horizontal screen and centering
will also change.
Note: Refer to the recommended resolution chart on
page 22.
Phase
This function allows you to remove any horizontal noise and
clear or sharpen the image of characters.
Auto
This function is for the automatic adjustment of the screen
position, clock and clock phase. The displayed image will disappear for a few
seconds while the Auto-configuration is in process.
Note: Some signal from some graphics boards may not function properly. If the
results are unsatisfactory, adjust your monitor’s position, clock and clock
phase manually.
Reset
This function allows you to return to the good picture reproduction programmed at
the factory and cannot be changed.
5. Press the TV/AV button to store the adjustment.
