NEC NP216 Projector User Manual


  Open as PDF
of 97
 
72
6. Maintenance
5. Connect the supplied power cable, and turn on the projector.
6. Finally, select the menu → [RESET] → [CLEAR LAMP HOURS] to reset the lamp usage hours.
NOTE:Whenyoucontinuetousetheprojectorforanother100hoursafterthelamphasreachedtheendofitslife,theprojector
cannot turn on and the menu is not displayed.
Ifthishappens,presstheHELPbuttonontheremotecontrolfor10secondstoresetthelampclockbacktozero.
Whenthelamptimeclockisresettozero,theLAMPindicatorgoesout.
4. Reattach the lamp cover.
(1) Slide the lamp cover back until it snaps into place.
(2) Tighten the screw to secure the lamp cover.
•Besuretotightenthescrew.
3. Install a new lamp housing.
(1) Insert a new lamp housing until the lamp housing is plugged into the socket.
CAUTION
Do not use a lamp other than the NEC replacement lamp NP13LP.
Order this from your NEC dealer.
(2) Push the top center of the lamp housing to secure it.
(3) Secure it in place with the three screws.
•Besuretotightenthescrews.
Hold the cabinet with your hand to keep it from tilting while you tighten the screw.
 previous next