Filter
Top Products
70
5. Using On-Screen Menu
[OPTIONS(1)]
Selecting Fan Mode [FAN MODE]
This option allows you to select three modes for fan speed: Auto mode, High speed mode, and High Altitude mode.
AUTO .....................The built-in fans automatically run at a variable speed according to the internal temperature.
HIGH
......................The built-in fans run at high speed.
HIGH ALTITUDE
.....The built-in fans run at a high speed. Select this option when using the projector at altitudes approximately
5500 feet/1700 meters (3000 feet/900 meters on V300X/V300W) or higher.
NOTE:
• When you wish to cool down the temperature inside the projector quickly, select [HIGH].
• It is recommended that you select High speed mode if you use the projector non-stop for consecutive days.
• If you use the projector at altitudes approximately 5500 feet/1700 meters (3000 feet/900 meters on V300X/V300W) or higher,
you are recommended to set [FAN MODE] to [HIGH ALTITUDE]. Failure to do so may cause the projector to overheat , resulting
in malfunction.
High altitude
V300X/V300W V260X/V230X/V260/V230/V260W
12000 ft (3600 m)
to
8500 ft (2600 m)
[HIGH ALTITUDE] for [FAN MODE]
5° to 30°C
(ECO MODE ON only)
[HIGH ALTITUDE] for [FAN MODE]
5° to 30°C
8500 ft (2600 m)
to
5500 ft (1700 m)
[HIGH ALTITUDE] for [FAN MODE]
5° to 35°C
[HIGH ALTITUDE] for [FAN MODE]
5° to 35°C
5500 ft (1700 m)
to
3000 ft (900 m)
[AUTO] for [FAN MODE]
5° to 40°C
3000 ft (900 m)
to
0
[AUTO] for [FAN MODE]
5° to 40°C
• Using the projector at altitudes approximately 5500 feet/1700 meters (3000 feet/900 meters on V300X/V300W) or higher without
setting to [HIGH ALTITUDE] can cause the projector to overheat and the protector could shut down. If this happens, wait a couple
minutes and turn on the projector.
• Using the projector at altitudes less than approximately 5500 feet/1700 meters (3000 feet/900 meters on V300X/V300W) and
setting to [HIGH ALTITUDE] can cause the lamp to overcool, causing the image to flicker. Switch [FAN MODE] to [AUTO].
• Using the projector at high altitudes or in low air pressure can shorten the life of components.
• Your setting will not be affected even when [RESET] is done from the menu.
Selecting [COLOR SYSTEM]
This feature enables you to select video standards manually.
Normally select [AUTO]. Select the video standard from the pulldown menu. This must be done for VIDEO and S-
VIDEO Connectors separately.