Filter
Top Products
Troubleshooting CE Declaration of Conformity
For the following equipment:
Wireless USB Adapter
MA111
is herewith confirmed to comply with the requirements set out in the Council Directive on the
Approximation of the Laws of the Member States relating to Electromagnetic Compatibility
and Radio Spectrum Matters (99/5/EC), Low-voltage Directive (73/23/EEC) and the
Amendment Directive (93/68/EEC). For the evaluation regarding the Directives, the following
standards were applied:
• EN 60950: 2000
• EN 301 489-17 V1.1.1:09-2000
• EN 301 489-1 V1.3.1:09-2001
• EN 300 328-1 V1.3.1: 12-2001
• EN 300 328-2 V1.2.1: 12-2001
Déclaration de conformité CE
Il est certifié que l’équipement suivant :
Wireless USB Adapter
MA111
est conforme aux exigences définies par la Directive du Conseil concernant le rapprochement
des législations des États Membres relatives à la compatibilité électromagnétique (99/5/EC), la
Directive sur les basses tensions (73/23/CEE) et la Directive d’amendement (93/68/CEE). Les
normes suivantes ont été appliquées pour évaluer la conformité à ces Directives :
• EN 60950: 2000
• EN 301 489-17 V1.1.1:09-2000
• EN 301 489-1 V1.3.1:09-2001
• EN 300 328-1 V1.3.1: 12-2001
• EN 300 328-2 V1.2.1: 12-2001
!
0682
!
0682
23
The LED is
blinking
repeatedly.
The Wireless USB Adapter
is not associated to any
Access Point properly. You
may not have configured
the wireless parameters of
the wireless nodes to be the
same as the Access Point.
• The Access Point may not be powered on.
• The Access Point and the MA111 Wireless
USB Adapter are not configured with the
same wireless parameters. Check the SSID,
and WEP encryption settings.
• The Access Point may be out of range. Try
moving the system closer to the Access Point
or readjusting the antenna on the Access
Point. You may also move the Access Point
to a higher location for better signal
reception by the Wireless USB Adapter.
I am associated
and connected
to an Access
Point, but I
cannot see the
other computers
on the Ethernet
side of the
network.
This could be a physical
layer problem or a network
configuration problem.
• Check to make sure that the Access Point
is physically connected to the Ethernet
network.
• Make sure that the IP addresses and the
Windows networking parameters are all
configured correctly.
Problem Cause Solution
No lights are lit
on the Wireless
USB Adapter.
The Wireless USB Adapter
is not inserted properly into
the USB port on your PC.
Or the proper MA111
Wireless USB Adapter
driver is not loaded.
• Remove and reinsert the Wireless
USB Adapter.
• Check the device manager in Windows to
see if the adapter card is properly
recognized in the Windows operating
system. Reload the driver if necessary.
• Try to install the Wireless USB Adapter in
different USB port if it’s available.