Filter
Top Products
FVS338 ProSafe VPN Firewall 50 Reference Manual
1-6 Introduction
v1.0, January 2007
Router Rear Panel
The rear panel of the ProSafe VPN Firewall 50 (Figure 1-2) contains the On/Off switch and AC
power connection.
Viewed from left to right, the rear panel contains the following elements:
Table 1-1. Object Descriptions
Object Activity Description
Power LED On (Green)
Off
Power is supplied to the router.
Power is not supplied to the router.
Test LED On (Amber)
Blinking (Amber)
Off
Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
MDM LED On (Green)
Blinking (Green)
Off
The serial port has successfully connected to an ISP and received an
IP Address.
Server data is being transmitted or received by the serial port.
The serial port has no link.
Internet
LEDs
Link/Act LED
On (Green)
Blinking (Green)
Off
The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.
100 LED
On (Green)
Off
The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.
Local LEDs Link/Act LED
On (Green)
Blinking (Green)
Off
The LAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the LAN port.
The LAN port has no link.
100 LED
On (Green)
Off
The LAN port is operating at 100 Mbps.
The LAN port is operating at 10 Mbps.
Figure 1-2
12VDC1.2A
INTERNET
LOCAL
1234
5
678MODEM
FACTORY
DEFAULTS