Filter
Top Products
Troubleshooting 7-1
202-10090-02 v 1.4, July 2005
Chapter 7
Troubleshooting
This chapter gives information about troubleshooting your WGT624 v3 108 Mbps Wireless
Firewall Router. After each problem description, instructions are provided to help you diagnose
and solve the problem.
Basic Functioning
After you turn on power to the router, the following sequence of events should occur:
1. When power is first applied, verify that the Power LED is on.
2. After approximately 10 seconds, verify that:
a. The Local port LEDs are lit for any local ports that are connected.
If a port’s LED is lit, a link has been established to the connected device. If a LAN port is
connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10
Mbps, the LED will be amber.
b. The Wireless port LED is lit. (Note: The LED is off in factory default setting and is
enabled/LIT after you run the Configuration Assistant.)
c. The Internet port LED is lit.
If any of these conditions does not occur, refer to the appropriate following section.
Power LED Not On
If the Power and other LEDs are off when your router is turned on:
• Make sure that the power cord is properly connected to your router and that the power supply
adapter is properly connected to a functioning power outlet.
Note: Product updates are available on the NETGEAR Web site at
www.netgear.com/support/main.asp. Documentation updates are available on the
NETGEAR, Inc. Web site at www.netgear.com/docs.