Filter
Top Products
2-4 Getting Started Guide
Netopia 4522 back panel
.
1. Connect the mini-DIN8 connector from the power adapter to the power port, and plug the other end into an
electrical outlet.
2. Connect one end of the Category 5 cable to the T1 port, and the other end to your T1 wall outlet.
3. Connect the Ethernet cable to the Ethernet port on the router and the other end to your computer.
You should now have: the power adapter plugged in; the Ethernet cable connected between the router and
your computer; and the T1 cable connected between the router and the T1 wall outlet.
Port Description
T1 WAN port An RJ-48 jack labeled WAN for your T1 connection.
Ethernet port RJ-45 10/100Base-T Ethernet jack. You will use this to configure the Netopia 4522. For
a new installation, use an Ethernet connection. Alternatively, you can use the console
connection to run console-based management using a direct serial connection. You can
either connect your computer directly to the Ethernet port using a crossover Ethernet
cable (not supplied), or connect both your computer and the Netopia 4522 to an existing
LAN environment.
Console port A DB-9 console port for a direct serial connection to the console screens. You can use
this if you are an experienced user. See “Connecting a Console Cable to Your Router” on
page 5-3.
Power port A mini-DIN8 power adapter cable connection.
WAN
10/100
Console Power
T1 port Ethernet port Console port Power port
Ethernet