Filter
Top Products
3
This release supports NCDware on a WinCenter server running
WinFrame 1.6 or later.
NCDware is provided on CD-ROM and PCMCIA cards.
Installing NCDware on UNIX Systems
The procedure in this section describes how to install NCDware on
the host and configure terminals to be used on the network.
For information on modifying or removing terminals from the
network, see the System Administrator’s Guide for UNIX Systems.
ncdinstall installs NCDware and configures terminals on most UNIX
systems.
Note If you are not sure if you can use ncdinstall on your UNIX
host, follow the installation instructions from Step 1
beginning on page 6 through Step 6 on page 8. After you
complete Step 7, a message displays if
ncdinstall cannot run
on your system. For information about manual installation,
call
NCD Technical Support.
ncdinstall performs the following:
❏ Examines the host system to ensure sufficient disk space. For
information on space requirements, see the Release Notes or the
file
SIZES on the CD-ROM.
❏ Examines the host system to ensure that required
communication and login software is running. If requested, the
installation program enables the software.