Filter
Top Products
Nikon
ScanTouch 210 User's Manual 21
SCSI Chain Connection with Other Devices
If your ScanTouch is connected at the end of the SCSI chain, install the
supplied terminator to the other SCSI connector on the rear of
ScanTouch. If your ScanTouch is connected between the other SCSI
devices, no terminator on ScanTouch is necessary.
Since the terminator is built into the host computer in most cases, the
host computer should be at the end of the SCSI chain. Some notebook
computers require a terminator to be attached outside the computer;
please refer to the operation manual for the computer.
Note: The SCSI cable used for SCSI connection should be of high-
impedance type.
other SCSI device
other SCSI device
other SCSI device
other SCSI device
Terminator
Terminator
ScanTouch
ScanTouch
ScanTouch
ScanTouch
4. Connecting the Scanner