Nikon LS-4500AF Scanner User Manual


 
21
Nikon
Film Scanner LS-4500AF User's Manual
4.4 Setting the SCSI ID
The SCSI ID for the LS-4500AF is set at “5” when the unit is shipped. If
other SCSI devices are connected to your computer, make sure that the
SCSI ID for the LS-4500AF is different from those assigned to other SCSI
devices.
SCSI ID
Note that in the case of a host computer which has a built-in SCSI hard
disk or built-in CD-ROM, the ID numbers of the host CPU and each SCSI
device have already been assigned.
If the IDs are the same, you must change the ID number of the other SCSI
device or the ID of the LS-4500AF to avoid any conflict.
Remarks
To change the ID, confirm that the LS-4500AF power is off. The ID
cannot be changed when the power is on.
As 7 has been assigned for the CPU and 0 has been assigned to the
built-in hard disk for a Macintosh, and 0 and 7 have also been assigned
to other personal computer systems, any number from 1 to 6 is recom-
mended for the ID number.
If the same ID numbers are assigned, the system might not function, or
important data on the hard disk might be destroyed. It is therefore
essential to check the ID numbers carefully before connecting the LS-
4500AF.
4. Connecting the LS-4500AF