Filter
Top Products
22
3. Installation
Before installing the SF-200 (S), make sure that your scanner is set up in a suitable location, as described
in the documentation provided with the scanner. The SF-200 (S) should not be used where:
• the temperature exceeds 35ºC (95ºF) or falls below 10ºC (50ºF)
• it would be subject to condensation or drastic changes in temperature
• the humidity exceeds 85%
• it would be exposed to direct or reflected sunlight
• it might be subject to vibration or strong physical shocks
• there is a lot of dust
• it would be exposed to radio interference from other electronic devices
• it would be exposed to water vapor (e.g., from a humidifier)
• it would be exposed to smoke
Warning: Failure to observe the above precautions could result in fire or in scanner
malfunction.
The scanner must be on its base when the SF-200 (S) is used, and there must be sufficient space around
the scanner to allow the magazine cover to open and to ensure adequate ventilation. There should be
at least 15 cm (6″) of space above the unit and 10 cm (4″) open to the rear. Space requirements when
the SF-200 (S) is attached are illustrated below.