© NOKIA INC | File: a032trbsv2.doc | Date: 15.08.01
INTERNET
3/11
INTRODUCTION
This document is intended to resolve common problems that may occur whilst using the Nokia A032
Access Point. It offers useful advice on avoiding general problems and preventing their re-occurrence.
This document is not intended to replace the User Manual but should be read in conjunction with it.
1. STARTUP PROBLEMS
This section provides on troubleshooting advice on Access Point initialization (startup) problems.
1.1 INITIALIZATION ERROR CODES
If the initialization procedure fails an error code should be displayed on the info LED’s and the alert
LED will remain on.
The code should be read from left to right. To identify the code write down each LED as a '1' or '0'
depending on its state (on = 1).
For example the pattern:
on on off off on off
would be written:
110010
The table below lists the error codes (a more detailed explanation of each code is given in the section
below the table.
Code Meaning Log Text
100001 Bad code image <none>
110000 Bad PCMCIA hardware PCMCIA hardware failure
110001 No PCMCIA No PCMCIA card detected
110010 Bad PCMCIA card Non-compatible PCMCIA card
110011 Bad radio (does not initialize) Cannot initialize radio
001000 Bad DRAM (stuck address) Memory error type 1
001001 Bad Ethernet RAM (stuck address) Memory error type 2
001010 Bad CMOS Memory Configuration error - default loaded
101000 LAN controller error LAN Interface Error
011000 Bad configuration Configuration error
011001 Bad Manufacturer's info Bad unit checksum
011010 Bad log sector Log sector bad — recovered
011011 System error System fault