Filter
Top Products
20 Configuring an MPANL tunneled through public frame relay
241-6401-280 6.0S1
Configure the 4400
CLI> def msm profile dnaPrefix "302102100501"
The Prefix DNA normally derives from link information.
For example:
DNIC 3021
RID 02
MID 10
Lp 05
Port 01
CLI> set system administration nodename "MPA_1"
A nodename is not required, but is typically included. Although not shown
in this example, the nodename appears within the CLI prompt.
CLI> def fr tunnel 149
CLI> add fr tunnel 149 21 limi 2 dtepanl
CLI> def fr line user dlcmipvc 155 ansi
If using release 2.0, use the following two commands in place of the
previous three commands:
CLI> def fr line user dlci lmitype 155 ansiT1617D-1994
CLI> define wan tunnelPVC dlci 153 21
where:
the 3rd party frame relay network supplies the DLCI number
CLI> save config update
CLI> reset system current reset
Configure the 6400
> start prov
PROV> add sw lpt/MPANL_MUX
PROV> set sw lpt/MPANL_MUX featureList mpaNetworkLink
frameRelayMux frameRelayUni frameRelayMmtc
PROV> check prov
PROV> act prov
PROV> save prov